In addition to the general ruler function, the other side can accurately locate the center between any two points, which is an indispensable gadget in the workshop.
Mutli-purpose measuring tool. Can be used as outside and inside try-square, miter-square, horizontal, 45° and plumb level, depth and marking gauge, rule, straight edge and scriber.
Japanese Combination Square is a 90º try square and a 45º miter square. Machined from stainless steel with graduations etched and black filled in 1/16" increments. The 1/2" flat base allows this square to stand by itself for power tool setup or it can be hooked on the edge of your stock for layout work. 4" tall by 6-1/4" long.
This versatile angle checker is an essential tool for quick and easy reading of blade angles on tools in the workshop as well as around the house.
The brass turning tool angle gauge has ten different angles cut out for easy and quick angle identificatiion Angle included: 15°,20°, 25° ,30° ,35° ,45° ,50° ,55° and 90°
Saw Step Gauge In Blister Card can be used to set blades on radial arm, hand held circular and table saws from 1/8" to 2" in 1/8" increments.
This multipurpose angle finder can measure, mark and transfer any angle whether inside, outside, barred angle or sloped angle.
Allows you to install and adjust planer knives quickly and accurately
Place the plastic center finder over the end of the piece, scribe a line, rotate the center finder about 90 degrees and scribe a second line.
Make transfers of large complex curves from your work piece or from a pattern by loosening the lock knobs, adjusting the steel curve and tightening the knobs.
Our all steel 6" engineer's square blade is ideal for setting up table saw blades, jointer fences, and other machine tools where accuracy is a must. It is also perfect for marking out wooden joints, both inside and outside, and checking cut stock.
Our all steel 4" engineer's square blade is ideal for setting up table saw blades, jointer fences, and other machine tools where accuracy is a must. It is also perfect for marking out wooden joints, both inside and outside, and checking cut stock.
This jointer knife setting jig lets you set jointer knives in perfect alignment and allows nicked knives to be shifted to get a perfect cut to an accuracy of ±.001-Inch.
This multi-purpose wood working tool can be used as square, angle finder and for marking. The base leg is 500mm long. It is light weight and easy to use.